Turbo Oxygen - A Complete Set-up Guide

O2E2 Oxygen Machine: The O2E2 Machine works by receiving the ambient air, filtering out nitrogen, and delivering oxygen-enriched air to the user with utmost efficiency.

Oxygen Reservoir Bag: The 500-liter and 900-liter oxygen reservoir bags collect oxygen from an economical, low-volume O2E2 Oxygen Machine eventually and deliver this high-volume oxygen to the user as and when required.

Turbo Mega-Flow Mask: Our patented Turbo Mega-Flow Mask offers double the oxygen flow in half the time with its innovative dual-inlet design.

Consult a physician: Consult with a qualified healthcare provider before beginning any new exercise regimen, especially if you have existing health conditions.

Proper Ventilation: Set up your Turbo Oxygen System in a well-ventilated area to ensure proper air circulation.

Secure Connections: Ensure all components are properly connected and secured.

Comfortable Breathing: Wear the Turbo Mega-Flow Mask comfortably to allow unrestricted breathing and avoid discomfort.

No Smoking or Flames: Do not smoke while your Turbo Oxygen System is operating or when you are near a person using the system. Keep your system at least 5 feet (1.6 m) from hot, sparking objects or naked sources of flame.

Maintenance: Regularly inspect and clean the exterior filter of the oxygen machine, Turbo Mega-Flow mask, hoses, and other components.

Discontinue if unwell: If you feel unwell or experience dizziness, nausea, or discomfort while exercising with Turbo Oxygen System, discontinue the session and seek medical attention if necessary.

Position your unit near an electrical outlet.

Position your unit at least 6 inches (16 cm) from walls, draperies, or any other objects that might prevent the proper flow of air in and out of your O2E2 machine.

Check the machine has an air filter at the back.

Attach the 14, 25, or 50-foot thin, smooth bore hose that came with the machine to the connector.

Hang the bag by grommet holes in the corners. Can be hung vertically, horizontally, or by all 4 corners to 9-foot minimum high ceiling.

If you have ordered a Bag Stand, 

Connect the oxygen tubing from the O2E2 machine to the small nipple on the bag.

Press the power switch of the O2E2 machine to the “ON” position. When the unit is turned on, all four lights on the front panel will illuminate briefly.

-- Power light

-- Normal Oxygen light (Oxygen Concentration≥82%)

-- Low Oxygen light (Oxygen Concentration between 70% and 82%)

-- Service Required light (Oxygen Concentration<70%)

After a few seconds, only the Power and Normal Oxygen lights will remain lit. The Audible Signal will briefly alarm.

Note 1 — If the Service Required light illuminates and the audible signal alarms but the unit is not operating, there is no power to the unit, Refer to the Troubleshooting table and contact us if necessary.

Note 2 — If an audible low-frequency vibration sound is detected, the unit is not operating properly. Refer to the Troubleshooting table and contact us if necessary.

Check the flow meter to make sure that the flow meter ball is centered on the line next to your required flow rate.

If the flow meter knob is turned clockwise, the flow decreases (and eventually will shut off the oxygen flow). If the knob is turned counterclockwise, the flow increases.

Note — Your O2E2 Oxygen Machine has a reserve oxygen system. If your unit loses electrical power or fails to operate correctly, the patient Alert System will sound to signal you to switch to your reserve oxygen system (if provided )and contact us.

Allow the Oxygen Reservoir Bag to fill with oxygen-enriched air. Filling times vary depending on the variant of the Reservoir Bag and the flow rate of the O2E2 Oxygen Machine.

900 Liter Reservoir Bag

--Time required to fill with a 10 LPM Oxygen Machine: ~1.5 hours (900/10=90 minutes)

--Time required to fill with a 5 LPM Oxygen Machine: ~3 hours (900/5=180 minutes)

500 Liter Reservoir Bag

--Time required to fill with a 10 LPM Oxygen Machine: ~1 hour (500/10=50 minutes)

--Time required to fill with a 5 LPM Oxygen Machine: ~1.5 hours (500/5=100 minutes)

Note - For a slow fill (for instance, 8-hour filling overnight or during the day), reduce the volume to 1 LPM for the 500-liter bag (8 x 60minutes = 480 liters) and 2 LPM for the 900-liter bag (8 x 120 minutes = 960 liters) and the pressure relief valve should prevent overfill (a little is ok as it will stretch a bit).

Once the bag is full, you can start your EWOT session

Take the Turbo Mega Flow Mask and connect the bag-to-mask connector hoses to each of the mask inlets.

Keep corks in large bag-to-mask hoses until you are ready to connect the Turbo Mega-Flow mask.

Remove corks to attach the mask to the hoses via the white adaptors. Fit the Mask to the face and adjust the head straps.

Tighten the upper straps first and then the lower ones. (Note: For some noses, a Breathe Right Strip can open the nostrils to allow more flow).

Position yourself in front of your chosen exercise equipment (for instance, treadmill, elliptical) and ensure the equipment is properly set up and adjusted for your session.

Before starting the exercise, begin with a gentle warm-up for a few minutes to prepare your body.

Start with a session duration that aligns with your fitness level. Start with an initial session duration of 10-15 minutes for beginners. As your comfort and fitness level increase, gradually extend the session duration up to 20 minutes.

After the session, disconnect the mask from the hoses and re-plug the corks at the hose end to save any balance of O2. (Note: Keep the O2E2 Machine running during the session to allow retaining of maximum O2 volume in the bag. After the session, return the cork to the large hose end to hold in O2 left in the bag.)

Equally Filled Bags: Utilize a second machine to fill a second bag. Connect the bags using a bag-to-mask large hose. This configuration provides a combined volume of 1,800 liters, ensuring a generous margin of error.

Guaranteed Safe Filling: The use of two bags, totaling 1,800 liters, combined with pressure relief valves, virtually eliminates the risk of overfilling, promoting a secure and worry-free experience.

Extended Session Duration: With a capacity of 1,800 liters, you can enjoy longer sessions without concerns about sufficient oxygen for each session.

Convenience for Multiple Users: The dual bag system makes it convenient for two individuals to use the system simultaneously or consecutively, ensuring an ample reserve of oxygen.

Do not use lubricants, oils or grease

Before attempting any cleaning procedures, turn the unit OFF.

Humidifier Bottle: Clean your humidifier bottle daily. Wash the humidifier in a solution of hot water and dishwashing detergent. Soak the humidifier in a solution of one part white vinegar to three parts hot water for 30 minutes. This solution acts as a germicidal agent. Rinse thoroughly with warm tap water and refill with distilled water for use. Do not overfill.

Cannula, Mask, and Tubing: Clean and replace the cannula, mask, and tubing

Air Filter and Oxygen Outlet Connector: The connector should not be cleaned at least once a week. To clean, follow these instructions.

-- Remove the oxygen outlet connector (if used).

-- Wash in a solution of warm water and dishwashing detergent.

-- Rinse thoroughly with warm tap water and towel dry. The filter should be completely dry before reinstalling.

Air filter needs to be replaced after the device operates every 3000 hours. The air filter is disposable after used. Not replacing the air filter regularly will affect the performance of concentration.

CAUTION—To prevent product damage, do not attempt to operate the unit without the air filter or while the filter is still damp.

Exterior Cabinet: Clean the concentrator exterior cabinet using a damp cloth or sponge with a mild household cleaner and wipe it dry.

WARNING — To avoid electric shock, do not remove the concentrator cabinet. The cabinet should only be removed by a qualified technician. Do not apply liquid directly to the cabinet or utilize any petroleum-based solvents or cleaning agents.

Clean the air filter at least once a week. Change the felt of the Inlet Pre-Filter at least once in half a year.

-- Open the Important Safeguard, pull out the Inlet Pre Filter, and pull out the old felts from the Inlet Pre-Filter (two sides).

-- Then insert the new felts to the Inlet Pre-Filter on each side, insert the Inlet Pre-Filter, and close the Important Safeguard.

Change the Bacterial Filter at least once a year. You can not change this by yourself, you must contact your CW Medical provider to change this for you.

Oxygen Reservoir Bag is designed to receive clean, dry oxygen and should remain free from any mold. The bag's anti-microbial lining further ensures hygiene during usage.

No need for cleaning the bag or hoses as you only inhale O2 from the bag and cannot exhale CO2 into the bag or hoses with the mask. Exhaling occurs through the mask's valves, releasing CO2 into the room.

If you feel you must clean the main breathing hose, any CPAP hose cleaner available in the market can be used. However, this step is generally unnecessary due to the system's inhalation-exhalation mechanism.

Keeping the system closed maintains a cleaner environment within the bag, as it prevents the introduction of potentially contaminated room air.

The Turbo Mega-Flow Mask is a medical-grade mask that can be cleaned using a gentle liquid soap, such as Miracle2.

The masks are designed to withstand autoclaving and sterilization procedures, making them suitable for medical settings requiring stringent cleanliness standards.

We recommend using separate masks for each user from a hygiene perspective. This practice ensures that each individual enjoys a clean and sanitary EWOT session, minimizing the potential transfer of germs or contaminants.